X
MENU
ENES

Products

Browse
Compare
Products
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
8FMB51

8FMB51

LF Drivers 8.0 inches

compare
Drawing
Datasheet
back
16_18_05_544_09_30_14_711_8fmb51rear16_18_05_520_09_30_14_707_8fmb51front16_18_05_141_09_30_14_700_8fmb51rear_b
Continuous power handling
Voice coil diameter
Magnet material
The FMB series mid-bass woofers from B&C Speakers offer acoustic designers a new range of high efficiency, wide bandwidth alternatives that are not currently available in the B&C range. These full-featured transducers incorporate lower cost ferrite motors, inside/outside wound copper clad aluminum wire voice coils, weatherproof impregnated paper cones, and a symmetrical inductance profile. The FMB Series is especially well suited for two-way loudspeaker enclosures.
 
 
 
 

Features

  • 500 W continuous program power capacity
  • 51 mm (2 in) aluminium voice coil
  • 68 - 4500 Hz response
  • 96 dB sensitivity
  • Ventilated voice coil gap for reduced power compression

Specifications

  • Nominal Diameter200 mm (8.0 in)
  • Nominal Impedance16 Ω
  • Minimum Impedance11.0 Ω
  • Nominal Power Handling1250 W
  • Continuous power handling2500 W
  • Sensitivity (1W/1m)396.0 dB
  • Frequency Range68 - 4500 Hz
  • Voice Coil Diameter51 mm (2.0 in)
  • Winding MaterialAluminium
  • Former MaterialGlass Fibre
  • Winding Depth15.0 mm (0.59 in)
  • Magnetic Gap Depth8.0 mm (0.31 in)
  • Flux Density1.19 T

Design

  • Surround ShapeTriple Roll
  • Cone ShapeCurvilinear
  • Magnet MaterialFerrite Ring
  • SpiderSingle
  • Pole DesignT-Pole
  • Woofer Cone TreatmentWaterproof Impregnated Cone
  • Recommended Enclosure14.0 dm3 (0.49 ft3)
  • Recommended Tuning80 Hz

Parameters4

  • Resonance Frequency68 Hz
  • Re9.8 Ω
  • Qes0.43
  • Qms4.1
  • Qts0.39
  • Vas20.5 dm3 (0.72 ft3)
  • Sd227.0 cm2 (35.19 in2)
  • η₀1.4 %
  • Xmax± 5.5 mm
  • Xvar± 5.0 mm
  • Mms19.7 g
  • Bl13.73 Txm
  • Le0.83 mH
  • EBP158 Hz

Mounting and Shipping Info

  • Overall Diameter225 mm (8.86 in)
  • Bolt Circle Diameter210 mm (8.27 in)
  • Baffle Cutout Diameter187.0 mm (7.36 in)
  • Depth92 mm (3.62 in)
  • Flange and Gasket Thickness9 mm (0.35 in)
  • Air Volume Occupied by Driver1.1 dm3 (0.04 ft3)
  • Net Weight4.0 kg (8.82 lb)
  • Shipping Units1
  • Shipping Weight4.45 kg (9.81 lb)
  • Shipping Box255x255x150 mm (10.04x10.04x5.91 in)
  • 2 hours test made with continuous pink noise signal within the range Fs-10Fs. Power calculated on rated minumum impedance. Loudspeaker in free air.
  • Power on Continuous Program is defined as 3 dB greater than the Nominal rating.
  • Applied RMS Voltage is set to 4 V for 16 ohms Nominal Impedance.
  • Thiele-Small parameters are measured after a high level 20 Hz sine wave preconditioning test.